Magnavox AJ3080 User manual, Danish - Page 4
Controls, Installation, Radio/clock - instructions
View all Magnavox AJ3080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
English CAJ3080/00 page 4 CONTROLS INSTALLATION RADIO/CLOCK TOP AND SIDE PANELS see fig. 1 MAINS CONNECTION 1 ALARM RESET - to stop the active alarm for 24 hours. 2 SLUMBER - to activate slumber time. 3 CLOCK: - RUN - To return to clock time display after setting clock/alarm time. - ALARM - To adjust/review the alarm time. - TIME SET - To adjust clock time. - HR - To adjust the hours for the clock and alarm time. - MIN - To adjust the minutes for the clock and alarm time. 4 SLUMBER OFF / REPEAT ALARM - to switch off slumber. - to stop the active alarm for a 9 minute period. 5 Display - To show the hours, minutes and activated alarm 6 BAND - to select FM-MW(LW) wave range. 7 VOLUME - for adjusting the volume. 8 TUNING - to tune to radio stations. 9 RADIO - to switch radio mode ON/OFF. 0 ALARM: - OFF - to switch off alarm. - RAD (io) - to activate radio for alarm setting. - BUZ (zer) - to activate buzzer for alarm setting. BACK PANEL see fig. 1 ! Battery door - for mains backup battery. @ Mains lead - for mains supply. # Pigtail aerial - for FM reception 1. Check if the mains voltage as shown on the type plate on the base of the set corresponds to your local mains supply. 2. Connect the mains plug into the wall socket. The mains supply is now switched on and the numbers on the display will start to flash. You will need to set the correct time. 3. To disconnect the set from the mains completely, withdraw the mains plug from the wall socket. For users in the U.K.: please follow the instructions on page 2. FM/MW (LW) RADIO You can use the clock radio solely as a radio. 1. Set the RADIO switch to ON. 2. Select your wave range using the BAND switch. 3. Use TUNING to find your radio station. 4. Adjust the sound with the VOLUME control. 5. To turn off the radio, set the RADIO switch to OFF. To improve radio reception - For MW (LW), the set is provided with a built-in aerial which to function best should be placed on a non-metallic surface e.g. wood, plastic. Direct the MW (LW) aerial by adjusting the position of your clock radio. - For FM reception extend the pigtail aerial at the back of the set completely to obtain optimum reception. CLOCK Clock display The time is displayed using the 24-hour clock system. Important! When setting the clock alarm time, for accurate hour and minute adjustment always make sure you press the HR and MIN buttons separately and not simultaneously. 4