Magnavox ZC320MW8B User manual, English (US) - Page 77

Introduction Connections Basic Setup Recording Playback TROUBLESHOOTING Before requesting service for this unit, check the table below for a possible cause of the problem you are experiencing. Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation. POWER GENERAL Symptom The power does not turn on. There is no picture. Picture noise appears. Playback picture from the external devices connected to this unit is distorted. Playback picture is distorted. There is no sound. Sound is noisy. No DTS sound is output. Menu cannot be called up. The remote control does not function. The disc does not play back. Remedy • Check that the AC power cord is connected securely. • Check the breaker (in case of power failure). • Re-connect the connecting cords securely. • Check if the connecting cords are damaged. • If the main menu appears on the TV screen, press [RETURN] to exit. • Check the connection to your TV (pages 14-17). • Check if the progressive scan mode is set correctly according to your TV (page 76). • Switch the input selector on your TV (such as to "L1") so that the signal from the unit appears on the TV screen. • Clean the disc with a cleaning cloth. • If the picture output signal from the external devices passes through this unit to get to your TV, the copy protection signal applied to some DVD could affect the picture quality. Disconnect the playback device in question and connect it directly to your TV. • Keep the device which may cause electrical disturbances, such as a cellular phone, away. • Clean the disc with a cleaning cloth. • Re-connect all connections securely. • Check if the connecting cord is damaged. • Check the connections to the amplifier input. • Check if the input device setting on the amplifier is correct. • When the unit is in pause mode or in slow-motion playback mode, sound is not output. This is not a malfunction. • When the unit is in fast forward or fast reverse mode, sound is not output. This is not a malfunction. • If you are using COAXIAL DIGITAL AUDIO OUTPUT jack, check the setting in "Disc Audio" (pages 71-72). • While the menu or timer programming display is shown, or while the screen saver is active, the audio is muted. • Clean the disc with a cleaning cloth. • This unit is not compatible with DTS sound. • Menus cannot be called up during DVD recording or DVD playback. • Batteries are weak. • There are obstacles between the remote control and the unit. • The remote control is far from the unit. • There are no batteries in the remote control. • Check if the unit is turned on. • Check if you are pointing the remote control at the recorder and NOT the TV. If you have a plasma TV, it may interfere with the IR signal. Try the remote with the plasma off. If the remote works, you may need to move the unit away from the plasma TV. • No disc is inserted. • A blank disc is inserted. • The disc is upside down. Insert the disc with the labeled side facing up. • The disc is not correctly inserted. • The unit cannot play back certain discs (such as a CD-ROM) (page 41). • The region code on the DVD-video does not match the unit (page 41). • Moisture has condensed inside the unit. Remove the disc and leave the unit turned on for about 2 hours until the moisture evaporates (page 3). • If the disc was recorded on another recorder, the unit cannot play back the disc if it was not finalized. REMOTE CONTROL PLAYBACK Editing Function Setup Others Español EN 77