Makita BFR750 Owners Manual - Page 7
Operation, Maintenance - bit
View all Makita BFR750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
1 2 1. Hook Driving in corner 1 2 1. Wall 2. Stopper base 1 1 008262 OPERATION Driving operation 008263 008284 15mm(5/8") This tool can be used to drive at a position 15 mm (5/8") away from the wall as shown in the figure. CAUTION: • Driving at a position closer than 15 mm (5/8") to the wall or driving with the stopper base in contact with the wall may damage the screw heads and cause wear on the bit. This may also lead to poor fastening of screws and malfunction of the tool. MAINTENANCE Switch on the tool by pulling the switch trigger. Hold the tool squarely and firmly up against the driving surface. A screw will be automatically carried to the driving position and fastened. CAUTION: • Always check the bit carefully for wear before driving operations. Replace a worn bit or poor fastening may result. • Always hold the tool squarely against the driving surface. Holding it at an angle may damage the screw heads and cause wear on the bit. This may also lead to poor fastening. • Always keep the tool firmly against the driving surface until the driving is over. Failure to do so may cause insufficient fastening of screws. • Be careful not to drive a screw onto another screw already fastened. • Do not operate the tool without screws. It will damage the driving surface. • Do not apply oil or grease on the sliding surface of the feeder box. CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. Replacing carbon brushes 1. Limit mark 1 006258 Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. Loosen the thumb screws which secure the casing. Pull out the casing in the direction of the arrow. 7