Makita GA7082 Instruction Manual - Page 10

To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. 1 Installing or removing abrasive disc Optional accessory 1 2 3 2 Fig.13 ► 1  . Lock nut wrench 2. Shaft lock To remove the wheel, follow the installation procedure in reverse. NOTE: In countries other than United States and Canada, Inner flange 45 can be also used. Installing or removing flex wheel Optional accessory WARNING: Always use supplied guard when flex wheel is on the tool. Wheel can shatter during use and guard helps to reduce chances of personal injury. 1 2 3 4 Fig.14 ► 1  . Lock nut 2. Flex wheel 3. Back up pad 4. Inner flange Follow instructions for depressed center wheel but also use back up pad over wheel. See order of assembly on accessories page in this manual. Fig.15 ► 1  . Sanding lock nut 2. Abrasive disc 3. Rubber pad 1. Mount the rubber pad onto the spindle. 2. Fit the disc on the rubber pad and screw the sanding lock nut onto the spindle. 3. Hold the spindle with the shaft lock, and securely tighten the sanding lock nut clockwise with the lock nut wrench. To remove the disc, follow the installation procedure in reverse. NOTE: Use sander accessories specified in this manual. These must be purchased separately. Installing or removing abrasive cutoff / diamond wheel Optional accessory WARNING: When using an abrasive cut-off / diamond wheel, be sure to use only the special wheel guard designed for use with cut-off wheels. WARNING: NEVER use cut-off wheel for side grinding. Mount the inner flange onto the spindle. Fit the wheel / disc on the inner flange and screw the lock nut onto the spindle. 1 2 3 4 Fig.16 ► 1  . Lock nut 2. Abrasive cut-off wheel / diamond wheel 3. Inner flange 4. Wheel guard for abrasive cut-off wheel / diamond wheel 10 ENGLISH