Makita GA7082 Instruction Manual - Page 13
Operation with abrasive cut-off, Operation with wire cup brush
View all Makita GA7082 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Operation with abrasive cut-off / diamond wheel Optional accessory WARNING: Do not "jam" the wheel or apply excessive pressure. Do not attempt to make an excessive depth of cut. Overstressing the wheel increases the loading and susceptibility to twisting or binding of the wheel in the cut and the possibility of kickback, wheel breakage and overheating of the motor may occur. WARNING: Do not start the cutting operation in the workpiece. Let the wheel reach full speed and carefully enter into the cut moving the tool forward over the workpiece surface. The wheel may bind, walk up or kickback if the power tool is started in the workpiece. WARNING: During cutting operations, never change the angle of the wheel. Placing side pressure on the cut-off wheel (as in grinding) will cause the wheel to crack and break, causing serious personal injury. WARNING: A diamond wheel shall be operated perpendicular to the material being cut. For model GA7080 and GA9080, you can rotate the switch handle. Usage example: operation with abrasive cut-off wheel with GA7080 / GA9080 Fig.24 Usage example: operation with abrasive cut-off wheel with GA7081 / GA7082 / GA9081 / GA9082 Usage example: operation with diamond wheel with GA7080 / GA9080 Fig.26 Usage example: operation with diamond wheel with GA7081 / GA7082 / GA9081 / GA9082 Fig.27 Operation with wire cup brush Optional accessory CAUTION: Check operation of brush by run- ning tool with no load, insuring that no one is in front of or in line with brush. NOTICE: Avoid applying too much pressure which causes over bending of wires when using the wire cup brush. It may lead to premature breakage. Usage example: operation with wire cup brush Fig.25 Fig.28 13 ENGLISH