Makita GA9080 Instruction Manual - Page 12
Operation
View all Makita GA9080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Dust collecting wheel guard for cut-off (for model GA9080 / GA9081 / GA9082) Fig.21 NOTE: For information how to install the dust collecting cover, refer to the manual of the dust collecting cover. Connecting a vacuum cleaner Optional accessory WARNING: Never vacuum metal particles generated by operation. Metal particles generated by such operation are so hot that they ignite dust and the filter inside the vacuum cleaner. To avoid dusty environment caused by masonry cutting, use a dust collecting wheel guard and a vacuum cleaner. Refer to the instruction manual attached to the dust collecting wheel guard for assembling and using it. 1 2 OPERATION WARNING: It should never be necessary to force the tool. The weight of the tool applies adequate pressure. Forcing and excessive pressure could cause dangerous wheel breakage. WARNING: ALWAYS replace wheel if tool is dropped while grinding. WARNING: NEVER hit the workpiece with the wheel. WARNING: Avoid bouncing and snagging the wheel, especially when working corners, sharp edges etc. This can cause loss of control and kickback. WARNING: NEVER use tool with wood cutting blades and other saw blades. Such blades when used on a grinder frequently kick and cause loss of control leading to personal injury. WARNING: Continued use of a worn-out wheel may result in wheel explosion and serious personal injury. CAUTION: Never switch on the tool when it is in contact with the workpiece, it may cause an injury to operator. CAUTION: Always wear safety goggles or a face shield during operation. CAUTION: After operation, always switch off the tool and wait until the wheel has come to a complete stop before putting the tool down. CAUTION: ALWAYS hold the tool firmly with one hand on housing and the other on the side grip (handle). Grinding and sanding operation Fig.22 ► 1 . Dust collecting wheel guard for cut-off 2. Hose of the vacuum cleaner 15° Fig.23 Turn the tool on and then apply the wheel or disc to the workpiece. In general, keep the edge of the wheel or disc at an angle of about 15° to the workpiece surface. During the break-in period with a new wheel, do not work the grinder in forward direction or it may cut into the workpiece. Once the edge of the wheel has been rounded off by use, the wheel may be worked in both forward and backward direction. 12 ENGLISH