Makita GA9080 Instruction Manual - Page 7
For tool with the lock-on switch, switch
View all Makita GA9080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Switch action CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. CAUTION: Make sure to switch off the tool in case of a blackout or accidental shut down such as unplugging of the power cord. Otherwise the tool will start unexpectedly when the power supply is recovered and cause an accident or personal injury. There are three patterns of the switch action depending on country. 2 1 A CB Fig.3 ► 1 . Switch trigger 2. Lock lever For tool with the lock-on switch Country specific CAUTION: Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply caution when locking tool in "ON" position and maintain firm grasp on tool. To start the tool, simply pull the switch trigger (in the B direction). Release the switch trigger to stop. For continuous operation, pull the switch trigger (in the B direction) and then push in the lock lever (in the A direction). To stop the tool from the locked position, pull the switch trigger fully (in the B direction), then release it. For tool with the lock-off switch Country specific (including Australia and New Zealand) To prevent the switch trigger from accidentally pulled, a lock lever is provided. To start the tool, push in the lock lever (in the A direction) and then pull the switch trigger (in the B direction). Release the switch trigger to stop. NOTICE: Do not pull the switch trigger hard without pressing in the lock lever. This can cause switch breakage. For tool with the lock-on and lock-off switch Country specific CAUTION: Switch can be locked in "ON" position for ease of operator comfort during extended use. Apply caution when locking tool in "ON" position and maintain firm grasp on tool. To prevent the switch trigger from accidentally pulled, a lock lever is provided. To start the tool, push in the lock lever (in the A direction) and then pull the switch trigger (in the B direction). Release the switch trigger to stop. For continuous operation, push in the lock lever (in the A direction), pull the switch trigger (in the B direction) and then pull the lock lever (in the C direction). To stop the tool from the locked position, pull the switch trigger fully (in the B direction), then release it. NOTICE: Do not pull the switch trigger hard without pressing in the lock lever. This can cause switch breakage. Indication lamp Only for model GA7080 / GA7081 / GA9080 / GA9081 1 Fig.4 ► 1 . Indication lamp The indication lamp lights up green when the tool is plugged. If the indication lamp does not light up, the mains cord or the controller may be defective. The indication lamp lights up but the tool does not start even if the tool is switched on, the carbon brushes may be worn out, or the controller, the motor or the switch may be defective. Unintentional restart proof Only for model GA7080 / GA7081 / GA9080 / GA9081 The tool does not start with the switch being lock-on even when the tool is plugged. At this time, the indication lamp blinks in red to show the unintentional restart proof device is working. To cancel the unintentional restart proof, return the switch to OFF position. NOTE: Wait more than one second before restarting the tool when unintentional restart proof works. 7 ENGLISH