Makita HB350 Instruction Manual - Page 6

EN WARNING! Always use safety chain. Moun�ng can release. . MAINTENANCE • Occasionally apply a few drops of oil to the rack toothing. • The bearings of the feed sha� are self- lubrica�ng and must not be greased. • Grease the sliding surface of the carriage with MOLYCOTE grease. • When not in use or being transported the unit should be kept in the case supplied. • A�er use ensure unit is clean of swarf and dirt. • Parts that are worn or damaged should be replaced immediately with genuine manufacturer's replacements. • Ensure all cu�ng edges are sharp when in opera�on. Using blunt cu�ng tools may lead to an overload of the motor. • A�er every 30 minutes running, it is recommended that the machine is laid on its side to permit grease to run across the gear train. • A�er repeated use, the cradle may become loose. This is remedied by adjus�ng the tension screws on the side of the body. Put 2.5mm hex wrench into head of cradle retaining nuts, using 8mm Spanner undo the locking nuts an�clockwise, holding the hex wrench without moving grub screws. Using the hex wrench gently �ghten screws in series un�l the cradle moves freely in the slide but does not allow the motor to wobble. When adjustment is complete re�ghten locking nuts clockwise, ensuring the grub screws do not move from their new posi�on IMPORTANT! - TO PREVENT DAMAGE TO THE CIRCUITRY, NEVER USE ELECTROMAGNETIC DRILLING MACHINES AND WELDING EQUIPMENT ON THE SAME WORKPIECE SIMULTANEOUSLY. Op�onal Accessories For details of op�ons, either refer to the catalog or inquire at the store of purchase or a Makita sales office. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. • HSS Cu�er • TCT Cu�er • Drill chuck