Makita HR4013C Owners Manual - Page 5
Speed change, Selecting the action mode - vibration
View all Makita HR4013C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Speed change 1 1. Adjusting dial 014029 The revolutions and blows per minute can be adjusted just by turning the adjusting dial. The dial is marked 1 (lowest speed) to 5 (full speed). Refer to the table below for the relationship between the number settings on the adjusting dial and the revolutions/blows per minute. • The speed adjusting dial can be turned only as far as 5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer work. Selecting the action mode CAUTION: • Do not rotate the change lever when the tool is running. The tool will be damaged. • To avoid rapid wear on the mode change mechanism, be sure that the change lever is always positively located in one of the action mode positions. Hammer drilling mode 1. Change lever 1 2. Pointer 2 For Model HR4003C, HR4013C Number on adjusting dial 5 4 3 2 1 014134 Revolutions per minute 500 470 380 290 250 Blows per minute 2,900 2,700 2,150 1,650 1,450 For Model HR5202C, HR5212C Number on adjusting dial 5 4 3 2 1 014872 Revolutions per minute 310 290 230 180 150 Blows per minute 2,250 2,100 1,700 1,300 1,100 For model HR4013C, HR5212C only NOTE: • Blows at no load per minute becomes smaller than those on load in order to reduce vibration under no load, but this does not show trouble. Once operation starts with a bit against concrete, blows per minute increase and get to the numbers as shown in the table. When temperature is low and there is less fluidity in grease, the tool may not have this function even with the motor rotating. CAUTION: • If the tool is operated continuously at low speeds for a long time, the motor may get overloaded, resulting in tool malfunction. 014022 For drilling in concrete, masonry, etc., rotate the change lever to the symbol. Use a tungsten-carbide tipped bit. Hammering mode (Switch trigger mode) 1. Change lever 1 2. Pointer 2 014024 For chipping, scaling or demolition operations, rotate the change lever to the symbol. Use a bull point, cold chisel, scaling chisel, etc. Hammering mode (Switch button mode) 1. Change lever 2 2. Pointer 1 014023 For continuous chipping, scaling or demolition operations, rotate the change lever to the symbol. 5