Makita HR4013C Owners Manual - Page 7
Installing or removing the bit, Bit angle when chipping, scaling or, demolishing, Depth gauge
View all Makita HR4013C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
The side grip swings around to either side, allowing easy handling of the tool in any position. Loosen the side grip by turning it counterclockwise, swing it to the desired position and then tighten it by turning clockwise. Installing or removing the bit 1 2 1. Bit shank 2. Bit grease Bit angle (when chipping, scaling or demolishing) 1. Change lever 1 2. Pointer 003150 Clean the bit shank and apply bit grease before installing the bit. 1. Bit 2. Release cover 1 2 014090 The bit can be secured at 24 different angles. To change the bit angle, rotate the change lever so that the pointer points to the symbol. Turn the bit to the desired angle. 1. Change lever 1 2. Pointer 2 014878 Insert the bit into the tool. Turn the bit and push it in until it engages. If the bit cannot be pushed in, remove the bit. Pull the release cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. 1. Bit 2. Release cover 2 014091 Rotate the change lever so that the pointer points to the symbol. Then make sure that the bit is securely held in place by turning it slightly. Depth gauge 2 1 1. Depth gauge 2. Lock button 1 2 014879 To remove the bit, pull the release cover down all the way and pull the bit out. 014033 The depth gauge is convenient for drilling holes of uniform depth. Press and hold the lock button, and insert the depth gauge into the hex hole. 7