Makita LXDT01Z Owners Manual - Page 9

Troubleshooting Trouble Light status/LED indicator status/tool status LED indicator for empty signal for remaining battery capacity lights up. The tool stops during operation. Light flickers once per second. Light flickers five times per second. Switch trigger has been pulled continuously for more than 130 seconds. Other Symptoms 011187 To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. • Screw bits • Hook • Plastic carrying case • Various type of Makita genuine batteries and chargers Steps to be taken Remaining battery capacity level is low. Charge the battery cartridge. When the LED indicator still lights up even after charging the battery cartridge, the tool temperature is high. Cool down it fully. The tool restarts after its temperature becomes low. When the status is still unchanged, stop using and have the tool repaired by a Makita local service center. The tool temperature is high. Cool down it fully. The tool restarts after its temperature becomes low. Use the tool with the motor not locked. (When the tool has stopped due to the motor locking, withdraw the battery cartridge one time and then insert it again or release the switch trigger for more than 60 seconds to restart the tool.) If the motor still remains locked, stop using and have the tool repaired by a Makita local service center. Release the switch trigger. Stop using and have the tool repaired by a Makita local service center. 9