Makita MP001GZ01 Instruction Manual - Page 7

Switch action WARNING: Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. WARNING: Do not attach a tape or such to keep the switch trigger in the "ON" position. To start the tool, simply pull the switch trigger. Release the switch trigger to stop. 1 ► 1 . Switch trigger Pressure gauge 6 1 7 2 8 9 3 4 5 8 Target pressure value 9 Pressure value unit If the object to be inflated is connected to the tool, the current pressure value of the object is displayed on the pressure gauge when you turn on the tool. If nothing is connected to the tool, the pressure gauge displays "0". The pressure gauge also displays the target pressure value, pressure value unit, and inflation mode. They are the same as the last time. When you start inflation, the inflation progress indicator is displayed. The inflation completes when the inflation progress indicator comes to the right end. Setting the target pressure value Press the [M] button, and select the pressure value unit. The pressure value unit is changed each time you press the [M] button. You can select one of the three units: PSI, BAR, or KPA. To increase the target pressure value, press the [+] button. To decrease the target pressure value, press the [-] button. You can set the target pressure value between 35 kPa (5 PSI) and 1,100 kPa (160 PSI). Setting the inflation mode Press the [M] button for 3 seconds. The inflation mode is changed each time you press and hold the [M] button. You can select one of the three modes as follows. Mode Ball Display Purpose To inflate balls Adjustable pressure range 35 to 110 kPa (5 to 16 PSI) Low speed High speed To inflate objects in low speed To inflate objects in high speed 35 to 1,100 kPa (5 to 160 PSI) NOTE: Be sure to select the ball mode when you inflate a ball using a sport ball needle. If other mode is selected, the inflation cannot be performed properly. NOTE: Be sure to select the low speed mode when you inflate an object using an English valve adapter. If other mode is selected, the inflation cannot be performed properly. 1 Overheat warning icon 2 Inflation mode 3 [-] button 4 [M] button 5 [+] button 6 Inflation progress indicator 7 Current pressure value 7 ENGLISH