Makita PC5001C Owners Manual - Page 6
Electronic function, Constant speed control, Soft start feature, Level planing for PC5001C only, - concrete planer
View all Makita PC5001C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
push in the lock lever (B) further. To stop the tool from the locked position, pull the switch trigger (A) fully, then release it. Electronic function Constant speed control • Possible to get fine finish, because the rotating speed is kept constantly even under the loaded condition. • Additionally, when the load on the tool exceeds admissible levels, power to the motor is reduced to protect the motor from overheating. When the load returns to admissible levels, the tool will operate as normal. Soft start feature • Soft start because of suppressed starting shock. Indication lamp 1. Indication lamp 1 To level a surface, the base of the planer should be aligned with the diamond wheel. The front roller should be adjusted (use hex wrench) upward to the level required for the desired stock removal amount. To change the amount of stock (concrete) removed, loosen the hex socket head bolts on the base holder with the hex wrench. Raise or lower the front roller to adjust the gap between it and the diamond wheel. The difference is the stock removal amount. Then secure the hex socket head bolts very carefully. 1. Hex socket head 1 bolt 2. Stock removal amount 2 009848 008416 The indication lamp lights up green when the tool is plugged. If the indication lamp does not light up, the mains cord or the controller may be defective. The indication lamp is lit but the tool does not start even if the tool is switched on, the carbon brushes may be worn out, or the controller, the motor or the ON/OFF switch may be defective. Unintentional restart proof Even locking lever keeping the switch trigger depressed (Lock-on position) does not allow the tool to restart even when the tool is plugged. At this time, the indication lamp flickers red and shows the unintentional restart proof device is on function. To cancel the unintentional restart proof, pull the switch trigger fully, then release it. Level planing (for PC5001C only) 1. Base (for PC5001C only) 2. Hex wrench 3. Front roller NOTE: • Maximum stock removal should be less than 4.0 mm. Tilting base for smoother planing ( for PC5001C only) 1. Base 1 2. Hex wrench 3. Hex socket head bolt 2 3 009849 For smooth removal of a given surface roughness or texture, tilting the base is helpful. Use the hex wrench to loosen the two hex socket head bolts securing the base on either side. Use a hex wrench to lower the three hex socket head bolts on the base by turning them on the base clockwise. 1. Hex wrench 2. Hex socket head 1 bolt 2 1 3 2 009847 009850 6