Makita PC5001C Owners Manual - Page 8

Connecting a vacuum cleaner 009881 To install a dust cover's brush, put the outer edge of the dust cover's brush in the groove in the dust cover. 009845 When you wish to perform clean planing operation, connect a Makita vacuum cleaner to your tool as shown in the figure. OPERATION 009882 And then expand the groove. With the groove being expanded, insert the inner edge of the dust cover's brush. Repeat this action and insert all the remaining part. Dust bag 1. Dust bag 1 009846 To install dust bag, slip onto dust port. Always make sure to slip onto dust port all the way until it stops so that it does not come off during operation. Remove dust bag when it begins to touch cutting surface. This is a sign that it is full. Failure to empty bag will lead to poor suction/pickup. 010273 Always use the top grip (auxiliary handle) and firmly hold the tool by top grip and switch handle during operations. Planing in corners For PC5000C Flush planing of corners is possible after first removing the dust cover cap. For PC5001C only 1. Dust cover cap 2. The whole roller 1 holder 3. Hex socket head bolt 4. Hex bolt 4 009883 3 2 Before performing the flush planing of corners, remove the hex bolt which secures roller holder and base holder and then take away the whole roller holder. Next, loosen the hex socket head bolt and take away the dust cover cap and then adjust the dust cover in a proper position according to your work. 8