Makita VC4210L VC4210L Instruction Manual - Page 19
After using the machine
View all Makita VC4210L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Makita VC4210L 3.6 Wet pick-up CAUTION The machine is equipped with a water level limit system which shuts off the machine when the maximum liquid level is reached. 1. When this occurs, switch off the machine. 2. Disconnect the machine from the socket and empty the container. 3. Never pick up liquids without the water level limit system and filter in place. 4. Do not pick up flammable liquids. 5. Before liquids are picked up, always remove the filter bag/wastebag and check that the water level limit works properly. 6. If foam appears, stop work immediately and emty the tank. 7. Clean the water level limiting device regularly and check for signs of damage. Before emptying the container, unplug the machine. Disconnect the hose from the inlet by pulling out the hose. Release the latches by pulling them outwards so that the motor top is released. Lift up the motor top from container. Always empty and clean the container and water level limit system after picking-up liquids. Empty by tilting the container backwards or sideways and pour the liquids into a floor drain or similar. Put back the motor top to the container. Secure the motor top with the latches. Heavy maneuvers can, by mistake, trigger the water level limiting device. Should this happen; turn off the machine and wait for 3 seconds to reset the device. Continue to operate the machine afterwards. 3.7 Dry pick-up CAUTION Picking up environmentally hazardous materials. Materials picked up can present a hazard to the environment. 1. Dispose of the dirt in accordance with legal regulations. Remove the electrical plug from the socket before emptying after dry pick-up. Release the latches by pulling them outwards so that the motor top is released. Lift up the motor top from container. Filter: Check the filters. To clean the filter you can shake, brush or wash it. Wait until the filter is dry before re-starting dust pick-up. Dust bag: check bag to ensure the fill factor. Replace dust bag if necessary. Remove the old bag. The new bag is fitted by passing the cardboard piece with the rubber membrane through the vacuum inlet. Make sure that the rubber membrane is passing past the heightening at the vacuum inlet. After emptying: close motor top to the container and secure the motor top with the latches. Never pick up dry material without filter fitted in the machine. The suction efficiency of the machine depends on the size and quality of the filter and dust bag. Therefore - use only Original filter and dust bags. 4 After using the machine 4.1 After use Remove the plug from the socket when machine is not in use. Wind up the cord starting from the machine. The power cord can be wound up around the motor top or at the container or placed in the included hook, or fastening means. Some variants have special storage places for accessories. 4.2 Transport 1. Before transporting the machine, close all the latches. 2. Do not tilt the machine if there are liquids in the dirt tank. 3. Do not use a crane hook to lift the machine. 4. Do not lift the machine by the trolley handle*) or the handle of the MAKPAC-Box*). 4.3 Storage CAUTION Store the appliance in a dry place, protected from rain and frost. The machine shall be stored indoors only. 4.4 Accessory and tool storage For convenient transport and storage of accessories or tools, integrated rails are found on side of machine which allows fastening with straps or other means. A flexible strap and hooks are included on back of machine for attachment of suction hose or mains cable. For instruction see quick reference guide. An optional adapter plate*) with attachment system can be installed on top of machine for fastening of 2-point or 4-point storage cases. *) Optional accessories / Option depending on model 17 Original instruction D GB F NL I N S DK SF E P GR TR SLO HR SK CZ PL H RO BG RUS EST LV LT AL MK SR UK