Makita XCU06Z XCU06T Instruction Manual - Page 16

Bucking 1. Rest the chain saw body on the wood to be cut. A B B A 2. With the saw chain running, saw into the wood while using the top handle to raise the saw and the front one to guide it. 3. Continue the cut by applying slight pressure to the top handle, easing the saw back slightly. NOTICE: When making several cuts, switch the chain saw off between cuts. CAUTION: If the upper edge of the bar is used for cutting, the chain saw may be deflected in your direction if the chain becomes trapped. For this reason, cut with the lower edge, so that the saw will be deflected away from your body. Limbing CAUTION: Limbing may only be performed by trained persons. A hazard is presented by the risk of kickback. When limbing, support the chain saw on the trunk if possible. Do not cut with the tip of the bar, as this presents a risk of kickback. Pay particular attention to branches under tension. Do not cut unsupported branches from below. Do not stand on the felled trunk when limbing. Carrying tool Before carrying the tool, always apply the chain brake and remove the battery cartridges from the tool. Then attach the guide bar cover. Also cover the battery cartridge with the battery cover. 1 2 When you cut a wood under tension, cut the pressured side (A) first. Then make the final cut from the tensioned side (B). This prevents the bar from becoming trapped. ► 1 . Guide bar cover 2. Battery cover MAINTENANCE CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. CAUTION: Always wear gloves when performing any inspection or maintenance. 16 ENGLISH