Makita XLC01ZB XLC01 Instruction Manual - Page 4

• Hard pieces with sharp edges, 4. If electrolyte gets into your eyes, such as wood chips, metals, rinse them out with clear water and stones, glasses, nails, pins or seek medical attention right away. It razors may result in loss of your eyesight. • Powder to clot such as cement 5. Do not short the battery cartridge: or toner (1) Do not touch the terminals with • Conductive dust such as metal any conductive material. or carbon • Fine particle like concrete dust (2) Avoid storing battery cartridge in a container with other metal Such action may cause fire, injury objects such as nails, coins, etc. and/or property damage. 3. Stop operation immediately if you (3) Do not expose battery cartridge to water or rain. notice anything abnormal. A battery short can cause a large 4. If you drop or strike the cleaner, check it carefully for cracks or dam- current flow, overheating, possible burns and even a breakdown. age before operation. 6. Do not store the tool and battery 5. Do not bring close to stoves or other heat sources. 6. Do not block the intake hole or vent holes. SAVE THESE INSTRUCTIONS. Symbols cartridge in locations where the temperature may reach or exceed 50 °C (122 °F). 7. Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. The battery cartridge can explode in a fire. 8. Be careful not to drop or strike battery. 9. Do not use a damaged battery. 10. The contained lithium-ion batteries The followings show the symbols used for tool. are subject to the Dangerous Goods volts Legislation requirements. For commercial transports e.g. by third direct current parties, forwarding agents, special requirement on packaging and labeling must be observed. Important safety instructions for battery cartridge For preparation of the item being shipped, consulting an expert for hazardous material is required. Please also observe possibly more detailed national regulations. Tape or mask off open contacts and pack up the battery in such a manner that it 1. Before using battery cartridge, cannot move around in the packaging. read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. 2. Do not disassemble battery cartridge. 11. Follow your local regulations relating to disposal of battery. 12. Use the batteries only with the products specified by Makita. Installing the batteries to non-compliant products may result in a fire, excessive heat, 3. If operating time has become explosion, or leak of electrolyte. excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. SAVE THESE INSTRUCTIONS. 4 ENGLISH