Makita XPS01Z XPS01 Instruction Manual - Page 10

Sighting 1 AB 1 2 ► 1 . Positive stopper 2. Clamping screw 48°-bevel cutting To perform 48°-bevel cutting, loosen the clamping screws and fully tilt the lever toward the direction of the arrow in the figure. Then set the bevel angle to 48° and tighten the clamping screws. 1 ► 1 . Lever -1°-bevel cutting To perform -1°-bevel cutting, loosen the clamping screws and press the levers toward the direction of the arrow in the figure. Then set the bevel angle to -1° and tighten the clamping screws. 1 ► 1 . Base The cutting line varies depending on the cutting angle and whether you use the guide rail (optional accessory). When using the tool without guide rail For straight cuts, align the A position on the front of the base with your cutting line. For 45° bevel cuts, align the B position with it. When using the tool with guide rail For both straight cuts and 45° bevel cuts, always align the A position on the front of the base with your cutting line. Switch action WARNING: Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. WARNING: NEVER defeat the lock-off button by taping down or some other means. A switch with a negated lock-off button may result in unintentional operation and serious personal injury. WARNING: NEVER use the tool if it runs when you simply pull the switch trigger without pressing the lock-off button. A switch in need of repair may result in unintentional operation and serious personal injury. Return tool to a Makita service center for proper repairs BEFORE further usage. To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. To start the tool, depress the lock-off button and pull the switch trigger. Release the switch trigger to stop. ► 1 . Lever 2 1 ► 1 . Switch trigger 2. Lock-off button 10 ENGLISH