Makita XPS01Z XPS01 Instruction Manual - Page 15
Maintenance
View all Makita XPS01Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
2. Adjust the blade angle. 0° 1 2 1 ► 1 . Front cutting point (165 mm blade) 2. Rear cutting point (165 mm blade) Guide device Optional accessory Use of the bevel guide allows exact miter cuts with angles and fitting works. Use of the clamp ensures firm hold of workpiece on the table. 45° 1 ► 1 . Triangular rule To adjust the 0°-cut accuracy, make the base perpendicular to the blade using a triangular rule, square rule, etc. by turning the adjusting bolt. MAINTENANCE CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. CAUTION: Clean out the guard to ensure there is no accumulated sawdust which may impede the operation of the guarding system. A dirty guarding system may limit the proper operation which could result in serious personal injury. The most effective way to accomplish this cleaning is with compressed air. If the dust is being blown out of the guard, be sure the proper eye and breathing protection is used. NOTICE: Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. Adjusting 0°-cut and 45°-cut accuracy NOTICE: Do not engage the levers for -1° bevel angle when adjusting 0°-cut accuracy. NOTICE: Do not engage the lever for 48° bevel angle when adjusting 45°-cut accuracy. These adjustments have been made at the factory. But if they are off, you can adjust them as the following procedures. 1. Slightly loosen the clamping screws on the front and rear of the tool. 1 ► 1 . Adjusting bolt for 0°-cut To adjust the 45°-cut accuracy, make the base 45° to the blade using a triangular rule by turning the adjusting bolt. 1 ► 1 . Adjusting bolt for 45°-cut 3. Tighten the clamping screws and make a test cut. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. 15 ENGLISH