Makita XPS01Z XPS01 Instruction Manual - Page 9
Positive stopper
View all Makita XPS01Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Bevel cutting Loosen the clamping screws. Set for the desired angle by tilting accordingly, then tighten the clamping screws securely. 1 1 2 ► 1 . Blade lower limit stopper 2. Clamping screw Quick stop button for 2 to 3 mm depth of cut when using guide rail (optional accessory) 1 2 This tool has the quick stop button for 2 to 3 mm depth of cut on the gear housing aside the rear handle when ► 1 . Clamping screw 2. Bevel scale plate using guide rail. This is used when avoiding splinter on the workpiece in the cut. Make a pass of the 2 to 3 mm 2 first cut and then make another pass of usual cut. 1 2 1 ► 1 . Sub base (optional accessory) 2. Clamping screw ► 1 . Quick stop button To obtain the 2 to 3 mm depth of cut, push in the quick stop button toward the saw blade. This is convenient for avoiding splinter on the workpiece. To release the depth of cut from this position for free depth of cut, just pull the button back. Positive stopper The positive stopper is useful for setting the designated angle quickly. Turn the positive stopper so that the arrow on it points 22.5°. Loosen the clamping screws in front and back. Then tilt the blade until it stops and secure the base with the clamping screws. 9 ENGLISH