Makita XSR01PT XSR01 Instruction Manual - Page 7
Tool / battery protection system, Indicating the remaining battery, capacity
View all Makita XSR01PT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
CAUTION: Always install the battery cartridge fully until the red indicator cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. CAUTION: Do not install the battery cartridge forcibly. If the cartridge does not slide in easily, it is not being inserted correctly. NOTE: The tool does not work with only one battery cartridge. Tool / battery protection system The tool is equipped with a tool/battery protection system. This system automatically cuts off power to the motor to extend tool and battery life. The tool will automatically stop during operation if the tool or battery is placed under one of the following conditions. Overload protection When the tool is operated in a manner that causes it to draw an abnormally high current, the tool automatically stops. In this situation, turn the tool off and stop the application that caused the tool to become overloaded. Then turn the tool on to restart. Overheat protection When the tool is overheated, the tool stops automatically, and the battery indicator blink about 60 seconds. In this situation, let the tool cool down before turning the tool on again. On Blinking Indicating the remaining battery capacity 1 2 ► 1 . Battery indicator 2. Check button Press the check button to indicate the remaining battery capacities. The battery indicators correspond to each battery. Battery indicator status On Off Blinking Remaining battery capacity 50% to 100% 20% to 50% 0% to 20% Overload alert If the tool is operated with excessive load, the mode indicator will blink in green. The mode indicator stops blinking and then lights up or turns off if you reduce the load on the tool. 1 Charge the battery Indicating the remaining battery capacity Only for battery cartridges with the indicator 1 2 ► 1 . Mode indicator Overdischarge protection When the battery capacity becomes low, the tool stops automatically. If the product does not operate even when the switches are operated, remove the batteries from the tool and charge the batteries. ► 1 . Indicator lamps 2. Check button Press the check button on the battery cartridge to indicate the remaining battery capacity. The indicator lamps light up for few seconds. 7 ENGLISH