Makita XSR01PT XSR01 Instruction Manual - Page 8
Positive stopper
View all Makita XSR01PT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Indicator lamps Remaining capacity Lighted Off Blinking 75% to 100% 50% to 75% 25% to 50% 0% to 25% Charge the battery. The battery may have malfunctioned. Adjusting depth of cut CAUTION: After adjusting the depth of cut, always tighten the lever securely. Loosen the lever on the depth guide and move the base up or down. At the desired depth of cut, secure the base by tightening the lever. For cleaner, safer cuts, set cut depth so that no more than one blade tooth projects below workpiece. Using proper cut depth helps to reduce potential for dangerous KICKBACKS which can cause personal injury. 1 NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. Automatic speed change function This tool has "high speed mode" and "high torque mode". The tool automatically changes the operation mode depending on the work load. When the the work load is low, the tool will run in the "high speed mode" for quicker cutting operation. When the the work load is high, the tool will run in the "high torque mode" for powerful cutting operation. 1 ► 1 . Lever Bevel cutting Loosen the lever and set for the desired angle by tilting accordingly, then tighten the lever securely. 1 ► 1 . Mode indicator The mode indicator lights up when the tool is running in "high torque mode". Mode indicator status On Off Operation mode High speed mode ► 1 . Lever Positive stopper The positive stopper is useful for setting the designated angle quickly. Turn the positive stopper so that the arrow on it points your desired bevel angle (22.5°/45°/53°). Loosen the lever and then tilt the tool base until it stops. The position where the tool base stops is the angle you set with the positive stopper. Tighten the lever with the tool base is at this position. High torque mode 8 ENGLISH