Marantz NR1601 NR1601 User Manual - English - Page 24

ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA Connecting an antenna • Connect the FM antenna or AM loop antenna supplied with the unit to enjoy listening to radio broadcasts. • After connecting the antenna and receiving a broadcast signal (vpage 24 "Listening to FM/AM broadcasts"), fix the antenna with tape in a position where the noise level becomes minimal. Direction of broadcasting station FM outdoor q w e antenna AM loop antenna (supplied) 75 Ω Coaxial cable Black White Connecting a wireless receiver (RX101) By connecting a wireless receiver RX101 (sold separately) to this unit, you can receive and playback audio signals from other devices using the Bluetooth Communication Function. • Use a Bluetooth device that is A2DP compatible (vpage 70 "A2DP"). • You can also use wireless receiver RX101 as an external IR receiver. • For instructions on the wireless receiver settings, refer to the RX101's operating instructions. Wireless receiver RX101 FM indoor antenna (supplied) Ground AM outdoor antenna nnAM loop antenna assembly 1 Put the stand section through the bottom of the loop antenna from the rear and bend it forward. Loop antenna 2 Insert the projecting part into the square hole in the stand. 20 nnUsing the AM loop antenna Suspending on a wall Suspend directly on a wall without assembling. Bluetooth device (A2DP Compatibility) Stand Square hole Projecting part Standing alone Use the procedure shown left to assemble. Nail, tack, etc. Remote control unit NOTE • Do not connect two FM antennas simultaneously. • Even if an external AM antenna is used, do not disconnect the AM loop antenna. • Make sure the AM loop antenna lead terminals do not touch metal parts of the panel. • If the signal has noise interference, connect the ground terminal (GND) to reduce noise. • If you are unable to receive a good broadcast signal, we recommend installing an outdoor antenna. For details, inquire at the retail store where you purchased the unit. You can enjoy listening to music by connecting a wireless receiver via the M-XPort input connector. In this case, set the input source to "M-XPort". NOTE To use wireless receiver RX101 as external IR receiver, set the remote sensor function of this unit to "DISABLE" (vpage 54 "Remote control settings").