Marantz NR1601 NR1601 User Manual - English - Page 60

ENGLISH DEUTSCH FRANÇAIS nnProgramming with the 4-digit code 1 Press and hold down the input source select buttons for the appliance to control, and press SET until the SEND indicator blinks twice. The back light flashes. 2 Press the 4-digit code for the appliance using the numeric buttons (code table at the end of this book). When the procedure is successful, the SEND indicator blinks twice. NOTE If the indicator did not blink twice, then repeat steps 1 and 2 and try entering the same code again. nnScanning the code table 1 Switch on the appliance to control. 2 Press and hold down the input source select buttons for the appliance to control, and press SET until the SEND indicator blinks twice. The back light flashes. 3 Aim the remote control at the appliance and slowly alternate between pressing INPUT d and the input source select buttons for the appliance. 4 Stop when the appliance turns off. 5 Press ENTER once to lock in the code. ITALIANO ESPAÑOL NEDERLANDS nnChecking the code 1 Press and hold down the input source select buttons for appliance to control, and press SET until the SEND indicator blinks twice and back light flashes. The back light flashes. 2 Press SEARCH/INFO. The SEND indicator blinks twice. 3 To view the code for first digit, press 1 once. Count the number of times the SEND indicator blinks (e.g. 3 blinks = 3) and write down the number. 4 Then press 2 to check the second digit of the code. Now press 3 and 4 to check the third and fourth digits of the code. NOTE If a code digit is "0", the SEND indicator does not blink. SVENSKA nnResetting the code Registering preset codes 1 Press and hold down the input source select buttons for appliance to control and press SET until the SEND indicator blinks twice. The back light flashes. 2 Press the codes below to reset the code. TV : 1000 DVD : 2000 CD : 3000 SAT : 4000 BD : 5000 The indicator will blink twice. NOTE After this procedure, the selected source reset to its initial code. 56