Marantz RX8001 User Guide - Page 10

RX8001 User Guide -or• a mini-jack IR cable. Insert one mini-jack connector of the mini-jack cable in the IR output of the Extender. Insert the other mini-jack connector in the A/V component. Adjusting the Power Level of the IR Outputs At the back of the Extender, there are 4 dipswitches, one for each IR output. Use these dipswitches to configure the power level of the Dual IR emitters and the mini-jack cables. For example, flip the dipswitch down to lower the power level when the Extender is connected to an external IR bus system. Support Troubleshooting What Do the LEDs Indicate? Colors LEDs Green blinking Ethernet LED The Extender's IP address is being determined. Green The Extender is functioning normally. Red/green blinking - WiFi LED The Extender's IP address is being determined. The Extender is functioning normally. - Red Red blinking Refer to the topic 'There is an IP conflict' on page 7. Refer to the topic 'The IP address cannot be determined' on page 7. Refer to the topic 'The Extender cannot communicate with the wireless network' on page 8. Busy LED The Extender is busy processing a short code or macro from the Control Panel. The Extender is busy processing a long macro from the Control Panel. The Extender is being configured. Refer to the topic 'There are duplicate Extender IDs' on page 8. The Extender is starting up. Wait until startup has finished. There is an IP conflict There is another A/V component in the network that is using the same fixed IP address as the Extender. Change the IP address of the Extender in the Configuration Tool. If the problem persists, check the router settings. The IP address cannot be determined • When using the Extender: make sure that the Extender is connected to the router with a straight Ethernet cable. • When configuring the Extender: make sure the PC is not using a fixed IP address but is using DHCP instead. 7