Marantz SA-11S3 SA11S3U_ENG_UG_v00 - Page 30

ENGLISH [USB/iPod] Problem Cause Corrective action "USB OC" appears • The voltage able to be on the display. supplied from this unit via the USB memory device has been exceeded. • The USB memory device is not supported. Please use a USB memory device with an operating current that is less than 1 A. • To clear the "USB OC", remove the USB memory device and turn this unit off and on. "Empty" appears on • No file able to be played on • Check supported formats. the display. this unit exists. The sound of the USB • The amplifier and speakers • Connect the cables memory device being are not connected properly. correctly. (See the connected is not instruction manual for the heard. amplifier.) • The amplifier power is not • Turn the amplifier power ON. ON. (See the instruction manual for the amplifier.) • The amplifier's function • Switch the amplifier's or selector switch is not function or selector set to "CD" or "AUX" or switch to "CD" or "AUX" such (to whatever you have or such (to whatever you connected this unit to). have connected this unit to). (See the instruction manual for the amplifier.) • The amplifier's volume control is set at the minimum level. • Adjust the amplifier volume. (See the instruction manual for the amplifier.) Page - - 18 - - - - Problem Cause Corrective action The sound of the iPod • The amplifier and speakers being connected is are not connected not heard. correctly. • Connect the cables correctly. (See the instruction manual for the amplifier.) • The amplifier power is not ON. • Turn ON the power to the amplifier. (See the instruction manual for the amplifier.) • The amplifier's function • Switch the amplifier's or selector switch is not function or selector set to "CD" or "AUX" or switch to "CD" or "AUX" such (to whatever you have or such (to whatever you connected this unit to). have connected this unit to). (See the instruction manual for the amplifier.) • The amplifier's volume control is set at the minimum level. • Adjust the amplifier volume. (See the instruction manual for the amplifier.) Reading of USB • When connecting a high- • Wait until reading is memory device takes capacity USB memory completed. time. device, it will take time to read depending on its capacity. Several minutes may be required for reading when using a high-capacity device. Power fails to switch • The unit's power switch on when the remote is off. controller's X CD is pressed. • Press the unit's power operation switch. • Or, press the unit's power operation switch, then press the remote controller's X CD. Page 10 - - - - 12 12 27