Marantz ST7001 ST7001 User Manual - Page 19
Checking the XM signal strength, and Radio ID - am fm xm tuner
View all Marantz ST7001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
ENGLISH OPERATION 7 Checking the XM signal strength and Radio ID 1. Press the POWER ON/STANDBY switch q or ON button , to turn on the power. 2. Watching the display, press the BAND SELECT button !0 or BAND button c to select the XM mode. 3. Press the DISPLAY button t or . twice. Signal status is displayed. • The display changes as shown below according to the receiving condition. Display Condition STRONG Signal strength is good MARGINAL Signal strength is marginal WEAK Signal strength is poor NO Loss of the signal 4. Adjust the antenna location until "SIGNAL:STRONG" is displayed. 5. Press the TUNING - button ⁄1 to select channel 0 (XM000). • The Radio ID is displayed. Radio ID Note • If "CHECK ANTENNA" appears in the front panel display, the XM Connect-and-Play antenna may not be connected to the XM terminal on the rear panel of this unit properly. • You can not select channel "0" if the All channel search mode is not selected. STANDBY POWER ON/STANDBY FM/AM TUNER ST7001 q TUNING/PRESET CATEGORY DISPLAY MENU A-PRESET SLEEP TIMER TUNED STEREO BAND SELECT PUSH ENTER t i !0 STANDBY ON c 1 2 3 4 5 6 7 8 9 DIMMER DISPLAY 10 TUNING BAND ENTER MENU A-PRESET /A-TUNE SHIFT CHANNEL/ CONTROL A/B C/D E/F G/H I/J T-MODE SLEEP TIMER MEMO . ⁄1 REMOTE CONTROLLER RC7001ST 15