Marantz ST7001 ST7001 User Manual - Page 9

ENGLISH PART NAMES AND FUNCTIONS REAR PANEL ANTENNA FM(75Ω) GND AM MODEL NO. ST7001 ANALOG OUT 1 2 L L XM R R RS-232C FLASHER IN REMOTE CONTROL IN OUT EXTERNAL INTERNAL AC IN AC OUTLET SWITCHED 100W MAX ab c d e fg h i j a FM antenna terminal (75 ohms) Connect an external FM antenna with a coaxial cable, or the supplied FM indoor antenna. b AM antenna and ground terminals Connect the supplied AM loop antenna. Use the terminals marked "AM" and "GND". The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best reception. c XM terminal See page 14 for connecting information. d ANALOG OUT 1, 2 (analog output) connectors The audio signals are output from these connectors. e RS-232C The RS-232C port is to be used in conjunction with an external controller to control the operation of the ST7001 by using an external device. f FLASHER IN (Flasher input terminal) This terminal is to control the unit from another zone. Connect the control signal from a Keypad, etc. g REMOTE CONTROL IN and OUT connectors Using the supplied remote control connecting cord, these connectors enable this unit to be connected to a Marantz component equipped with remote control connectors. These connections make it possible to control an entire system that centers on the amplifier or other such component. h EXTERNAL/INTERNAL switch Before the unit was shipped from the factory, this switch was set to INTERNAL to enable the remote sensor built into the unit to be used. Before using the supplied connecting cord to make the connection between the unit and the remote control connectors on a Marantz equipment, set the switch to EXTERNAL. Note • Signals cannot be received from the remote control unit if the switch is kept at EXTERNAL when the unit is to be used on its own. i AC INLET Plug the supplied mains cord into this AC INLET and then into the power outlet on the wall. ST7001 can be powered by 120V AC only. j AC OUTLET Connect the AC mains cord of components such as a MD or Tape Deck to this outlet. This SWITCHED outlet provides power only when the ST7001 is turned on. Caution • In order to avoid potential turn-off thumps, anything plugged into this outlet should be powered up before the ST7001 is turned on. • The capacity of this AC outlet is 100W. Do not connect devices that consume electricity more than the capacity of this AC outlet. 5