Maytag HRE2940T User Guide - Page 18

Instructions for Installation (cont'd) Installation Checklist 1. Whether or not the element conversion is made, the model HOT rating plate must be marked. Using a hard point ink pen, check the appropriate block within the model rating plate, which is located adjacent to the lower access panel. COLD 2. Is the fuse or circuit breaker size correct as shown in the chart in the "Product Specifications" section? 3. Are the wires from the circuit breaker or fuse service to the water heater's junction box on the correct wire size (gauge) as shown in the chart in the "Product Specifications" section? CONDUIT HOT COLD TEMPERATUREPRESSURE RELIEF VALVE 4. Is the new temperature-pressure relief valve properly installed, and piped to an adequate drain? See "Temperature-Pressure Relief Valve" in the "Instructions for Installation" section. 5. Is the water heater completely filled with water? See "Filling the Water Heater" instructions in the "Instructions for Installation" section. DISCHARGE PIPE (Do not cap or plug) 6. Will a water leak damage anything? See "Locating the New Water Heater" in the "Instructions for Installation" section. 7. Are the cold and hot water lines connected to the water heater correctly? See "Water Piping" instructions in the "Instructions for Installation" section. 6″ AIR GAP FLOOR DRAIN 8. Is there adequate clearance for maintenance around the water heater? 9. Do you need to call your electric company to check your wiring? MODEL RATING PLATE 18