Maytag MDB7609AWB Installation Instructions - Page 21

Electrical, Operate, Additional - canada

Page 21 highlights

ElectricaSlhock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Power supply cord--Plug i a grounded 3 prong outlet Plug into a grounded 3 prong outlet. Check that power supply cord does not touch dishwasher motor or lower part of dishwasher tub. Reconnect Power Check Operation [:_ Read the Dishwasher User Instructions that came with your dishwasher. [:_ Check that all parts have been installed and no steps were skipped. Check that you have all tools used. Ci Start dishwasher and allow it to complete the shortest wash cycle. After the first 2 minutes unlatch door, wait 5 seconds, then open door. Check that there is water in the bottom of the dishwasher tub. Check that dishwasher is working properly. If the dishwasher is not working properly, disconnect power or unplug dishwasher and see "If Dishwasher Does Not Operate" section. If Dishwasher Does Not Operate First try the solutions suggested here to possibly avoid the cost of a service call. • Has the circuit breaker tripped or the house fuse blown? • Is the door closed tightly and latched? • Has the cycle been set correctly to start the dishwasher? • Is the water turned on? If none of these solve the problem, call 1-800-688-9900, or in Canada, call 1-800-807-6777. Additional Tips Expect longer wash times. Your new dishwasher will average 2 to 3 hours per load, but use nearly 40% less energy than older models. Designed with a low wattage, low energy consumption motor, your dishwasher washes longer to ensure exceptional cleaning. Certain models are equipped with an optical water sensor so the first cycle will run longer to calibrate to optical sensor. Selecting certain options could increase cycle time past 3.5 hours. Rinse Aid is necessary for good drying results: This dishwasher is designed to be used with rinse aid for good drying performance and controlling hard water deposit buildup. Energy efficient dishwashers use less water and energy so they depend on the water sheeting action of rinse aid for good drying performance. Start/Resume light may flash: When pressing Start/Resume, you must make sure the door is closed within 3 seconds. If you do not close the door, the Start/Resume light will flash until you press it again. (You must also do this when adding a dish during the middle of a cycle.) 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

Electrical
Shock
Hazard
Plug into
a grounded
3 prong outlet.
Do not remove
ground
prong.
Do not use an adapter.
Do not
use
an extension
cord.
Failure
to follow
these
instructions
can result
in
death,
fire,
or
electrical
shock.
Power
supply
cord--Plug
i
a grounded
3 prong
outlet
Plug into
a grounded
3 prong
outlet.
Check that
power
supply
cord
does
not touch
dishwasher
motor
or lower
part of dishwasher
tub.
Reconnect
Power
Check Operation
[:_ Read the
Dishwasher
User
Instructions
that
came
with
your
dishwasher.
[:_ Check that
all parts
have been installed
and no steps
were
skipped.
Check that
you
have all tools
used.
Ci
Start
dishwasher
and allow
it to complete
the
shortest
wash
cycle. After
the
first
2 minutes
unlatch
door,
wait
5 seconds,
then
open
door.
Check that there
is
water
in the
bottom
of the
dishwasher
tub.
Check that
dishwasher
is working
properly.
If the dishwasher
is not working
properly,
disconnect
power
or
unplug
dishwasher
and see "If Dishwasher
Does Not Operate"
section.
If Dishwasher
Does
Not
Operate
First try the
solutions
suggested
here to possibly
avoid
the cost
of a service
call.
• Has the circuit
breaker
tripped
or the
house
fuse
blown?
• Is the door
closed
tightly
and latched?
• Has the cycle
been set correctly
to start
the
dishwasher?
• Is the water
turned
on?
If none
of these
solve
the
problem,
call
1-800-688-9900,
or in Canada,
call
1-800-807-6777.
Additional
Tips
Expect
longer
wash
times.
Your
new
dishwasher
will
average
2 to 3 hours
per load,
but use nearly
40% less
energy
than
older
models.
Designed
with
a low wattage,
low energy
consumption
motor,
your
dishwasher
washes
longer
to ensure
exceptional
cleaning.
Certain
models
are equipped
with
an optical
water
sensor
so the
first
cycle
will
run longer
to calibrate
to optical
sensor.
Selecting
certain
options
could
increase
cycle
time
past
3.5 hours.
Rinse Aid
is necessary
for good
drying
results:
This
dishwasher
is designed
to
be used with
rinse aid for
good
drying
performance
and controlling
hard
water
deposit
buildup.
Energy
efficient
dishwashers
use less
water
and energy
so they
depend
on the water
sheeting
action
of rinse
aid for good
drying
performance.
Start/Resume
light
may
flash:
When
pressing
Start/Resume,
you
must
make sure the
door
is closed
within
3 seconds.
If you
do not close
the
door, the
Start/Resume
light
will
flash
until
you
press it
again.
(You must
also do this
when
adding
a dish
during
the middle
of a cycle.)
21