Maytag MDB7949SDZ Use & Care Guide - Page 6
Powders and Gels, STEP 3, Rinse Aid, Rinse Aid Setting
View all Maytag MDB7949SDZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
To close lid To open lid SLIDE SLIDE Rinse Aid STEP 3 Place selected detergent in the dispenser. Place finger, as shown, and slide lid closed. Press firmly until it clicks. Push OPEN, as shown, and the lid will slide open. Powders and Gels Water Hardness Soil Level Prewash Main Wash Compartment* Compartment Soft (0-4 grains per U.S. gallon) Light Normal Heavy None None Full "Soft" fill line "Soft" fill line "Soft" fill line Medium (5-9 grains per U.S. gallon) Light Normal Heavy None Full Full "Soft" fill line Full** Full** Hard Light Full Full** (10-14 grains Normal Full per U.S. gallon) Heavy Full Full** Full** *The prewash compartment is on top of the sliding door of the dispenser. **A full main wash compartment contains 2 Tbsp. (30 ml). IMPORTANT: Extremely hard water mineral deposits (15 grains per U.S. gallon or more) can cause damage to your dishwasher and make it difficult to achieve good results. A water softener is recommended to avoid damage and achieve good results. NOTE: Follow instructions on the package when using other dishwasher detergent types. SLIDE IMPORTANT: Your dishwasher is designed to use rinse aid. The use of rinse aids greatly improves drying by allowing water to drain from the dishes after the final rinse. Rinse aid also keeps water from forming droplets that can dry as spots or streaks. Filling the dispenser The dispenser holds 5 oz (150 mL) of rinse aid. Under most conditions this will last Full 1 to 3 months. NOTE: Indicator reads correct fill level Add when door is completely opened. 1. To add rinse aid, open the rinse dispenser lid by gently pushing in the center of the lid with your thumb and pulling up on the edge. Pre Wash SLIDE OPEN 2. Pour rinse aid into the opening until the dispenser is full. Do not overfill. 3. Clean up any spilled rinse aid. Spilled rinse aid can create excessive suds. 4. Then, close the dispenser by pushing down gently on the lid. Rinse Aid Setting Your rinse aid dispenser is adjustable. For most water conditions, the factory setting will give good results. If you have hard water and notice calcium buildup on your dishware, you may want to try a higher setting. If you notice foam in your dishwasher, use a lower setting. To adjust the setting: Turn the arrow adjuster to a higher number to increase the amount of rinse aid. 6