Maytag MED5630H Owners Manual - Page 13
Wire Power Supply Cord Connection, Remove center screw
View all Maytag MED5630H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
4. Connect neutral ground wire and neutral wire 3-Wire Power Supply Cord Connection IMPORTANT: Use where local codes permit connecting cabinetground conductor to neutral wire. Connect neutral ground wire (E) and neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw. 5. Connect ground wire A. 3-wire receptacle (NEMA type 10-30R) B. 3-wire plug C. Neutral prong D. Spade terminals with upturned ends E. 3/4" (19 mm) UL-listed strain relief F. Ring terminals G. Neutral (white or center wire) 3. Remove center screw Connect ground wire (F) (green or bare) of power supply cord under green external ground conductor screw (A). Tighten screw. 6. Connect remaining wires Remove center terminal block screw (B). 4. Connect neutral wire Connect remaining wires under outer terminal block screws. Tighten screws. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." Connect neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw. 13