Maytag MED5630H Owners Manual - Page 14

5. Connect remaining wires Connect remaining wires under outer terminal block screws. Tighten screws. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." Direct Wire Connection Direct wire strain relief 1. Attach direct wire strain relief For 4-wire Direct Wire Connection, continue to step 3. 4-wire direct wire connection: Go to "4-Wire Direct Wire Connection." For 3-wire Direct Wire Connection, continue to step 3. 3-wire direct wire connection: Go to "3-Wire Direct Wire Connection." 4-Wire Direct Wire Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit 3-wire connections. 3. Prepare your 4-wire cable for direct connection Unscrew the removable conduit connector (A) and any screws from a 3/4" (19 mm) UL-listed strain relief (UL marking on strain relief). Put the threaded section of the strain relief through the hole below the terminal block opening (B). Reaching inside the terminal block opening, screw the removable conduit connector (A) onto the strain relief threads (C) and tighten securely. 2. Attach direct wire cable to strain relief Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 5" (127 mm) of outer covering from end of cable, leaving bare ground wire at 5" (127 mm). Cut 1 1/2" (38 mm) from remaining 3 wires. Strip insulation back 1" (25 mm). Shape ends of wires into hooks. 4. Prepare to connect neutral ground wire and neutral wire Remove center terminal block screw (B). Remove neutral ground wire (E) from green external ground conductor screw (A). Put direct wire cable through the strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Tighten strain relief screw against the direct wire cable. 14