Maytag MED8200FC Installation Guide - Page 19
Remove outer window assembly, from trim ring, Move the door strike, Remove inner door from outer
View all Maytag MED8200FC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
2. Move the door strike 4. Remove outer window assembly from trim ring Using a T25® screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Rotate the strike 180° and attach to the opposite side of dryer door frame as shown. 3. Remove inner door from outer door Fig. A Fig. B Using a Phillips screwdriver, remove the 2 screws from the outer window retainer and rotate the outer window assembly clockwise until the square notches line up with the 4 tabs on the trim ring indicated with arrows in the figure A above. Then lift out the outer window and retainer up and off the trim ring and set aside (B). Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 10 screws securing the inner door to the outer door. Lift off the inner door and set aside. †®TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC. 19