Maytag MEDB955F Installation Instructions - Page 12
Connect remaining wires, Connect neutral wire, Remove center screw, Attach direct wire strain relief
![]() |
View all Maytag MEDB955F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
3-wire Power Supply Cord Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. 3. Connect remaining wires 3-wire receptacle (NEMA type 10-30R) 3-prong plug Spade terminals with upturned ends Ring terminals 1. Remove center screw Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." DIRECT WIRE CONNECTION B Remove center terminal block screw (B). 2. Connect neutral wire C B Connect neutral wire (white or center) (C) of power supply cord to center terminal block screw (B). Tighten screw. Direct Wire Strain Relief 1. Attach direct wire strain relief A B C Unscrew the removable conduit connector (A) and any screws from a 3/4" (19 mm) UL listed strain relief (UL marking 12
![](/manual_guide/products/maytag-mgdb955f-installation-instructions-34a510d/12.png)