Maytag MEDB955F Installation Instructions - Page 22
Reverse Door Swing
View all Maytag MEDB955F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
REVERSE DOOR SWING Tools needed: 4. R emove the dryer door from the cabinet by lifting upward and out. Lay the door on a towel or a soft cloth you placed on a flat workspace. Plastic putty knife Min. 8" long TORX T20® † screwdriver #2 Phillips screwdriver Optional Assembly Kit Covers You can change your door swing from a right-hinge opening to a left-hinge opening, if desired. Note:To complete the door swing reversal exactly as seen in these instructions, a door reversal kit must be purchased. For ordering information, please reference the "Use and Care Guide." 1. Place a towel or soft cloth on a flat workspace such as a floor to avoid damaging the dryer's surface or the dryer door. Remove door from dryer cabinet 1. Open the dryer door. 2. Use a plastic putty knife to remove the hinge covers and plastic covers from the front panel of the dryer. Set them aside. 5. Use a plastic putty knife to remove the door hinge covers. Set them aside. 3. Using a T20® screwdriver, remove screws (A) and then screws (B) from each of the 2 hinges attaching the dryer door to the front panel of the dryer. Set the hinge screws off to the side for use in reinstalling the door. 6. Using a #2 Phillips screwdriver, remove the remaining 4 screws from the hinges. Then remove hinges A and B and set both the screws and hinges aside. A B A B B A † ® TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC. 22