Maytag MEDP576K Installation Instructions - Page 8

INSTALL LEVELING LEGS 1. Prepare dryer for leveling legs To avoid damaging oor, use a large at piece of cardboard from dryer carton; place under entire back edge of dryer. Firmly grasp dryer body (not console panel) and gently lay dryer down on cardboard. 2. Screw in leveling legs ELECTRICAL CONNECTION 1. Choose electrical connection type Power supply cord 4-wire receptacle (NEMA Type 14-30R): Go to "4-Wire Power Supply Cord Connection" section. Then, go to "Venting Requirements." Power supply cord 3-wire receptacle (NEMA Type 10-30R): Go to "3-Wire Power Supply Cord Connection" section. Then go to "Venting Requirements." 4-wire direct connection: Go to "4-Wire Direct Wire Connection" section. Then go to "Venting Requirements.". 3-wire direct connection: Go to "3-Wire Direct Wire Connection" section. Then go to "Venting Requirements." NOTE: If local codes do not permit connection of a cabinet-ground conductor to neutral wire, go to "Optional 3-Wire Connection" section. This connection may be used with either a power supply cord or a direct wire connection. 2. Remove terminal block cover B C A Using a wrench and tape measure, screw legs into leg holes until bottom of foot is approximately 1½" (38 mm) from bottom of dryer. Now stand the dryer on its legs. Slide the dryer until it is close to its final location. Leave enough room for electrical connection and to connect the exhaust vent. NOTE: Refer to "Dryer Dimensions" in "Location Requirements." D E F Before you start, disconnect power. Remove hold-down screw (D) and terminal block cover (A). A. Terminal block cover B. External ground conductor screw C. Center terminal block screw D. Hold-down screw E. Neutral ground wire F. Hole below terminal block cover 8