Maytag MEDX700XL Installation Instructions - Page 11
wire Direct Wire Connection
UPC - 883049199115
View all Maytag MEDX700XL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3. Connect neutral ground wire and neutral wire B C E Connect neutral ground wire (E) and place hooked end (hook facing right) of neutral wire (white or center wire) (C) of direct wire cable under center screw of terminal block (B). Squeeze hooked ends together and tighten screw. 4. Connect ground wire 3-wire Direct Wire Connection IMPORTANT: Use where local codes permit connecting cabinet-ground conductor to neutral wire. 1. Prepare your 3-wire cable for direct connection (251"mm) (893m½m" ) Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 31/2" (89 mm) of outer covering from end of cable. Strip insulation back 1" (25 mm). If using 3-wire cable with ground wire, cut bare wire even with outer covering. Shape wire ends into hooks. 2. Remove center screw B AF Connect ground wire (green or bare) (F) of direct wire cable to external ground conductor screw (A). Tighten screw. 5. Connect remaining wires Remove center terminal block screw (B). Place hooked ends of remaining direct wire cable wires under outer terminal block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting Requirements." 11