Maytag MEDZ600TB Use and Care Guide - Page 25

Select the correct cycle and dryness level or temperature for your load. If a Sensor Dry Cycle is running, the display shows the estimated cycle time, which is determined by your dryer automatically sensing the dryness level of your load. [f a Timed Dry Cycle is running, the display shows the exact number of minutes remaining in the cycle. Cool Down tumbles the load without heat during the last few minutes of all cycles. Cool Down makes the loads easier to handle and reduces wrinkling. The length of the Cool [)own depends on the load size and dryness level. Drying tips • Follow care label directions when they are available. • If desired, add a fabric softener sheet. Follow package instructions. • [b reduce wrinkling, remove the load from the dryer as soon as tumbling stops. [-his is especially important for permanent press, knits, and synthetic fabrics. • Avoid drying heavy work clothes together with lighter fabrics. This could cause overdrying of lighter fabrics and lead to increased shrinkage or wrinkling. Cycle tips • Dry most loads using the preset cycle settings. • Refer to the Sensor Dry Cycles or Timed Dry Cycles Preset Settings chart (in the "Cycles" section) for a guide to drying various loads. • Drying temperature and Dryness I.evel are preset when you choose an Sensor Dry Cycle. You can select a different dryness level, depending on your load, by pressing Dryness level and choosing More or less. NOTE: You cannot use the Timed Dry Cycle Adjust Up or Down arrow buttons and you cannot modify temperature with the Sensor Dry cycles. • [f you wish to adjust the cycle length of a Timed Dry Cycle, press the Timed Dry Cycle Adjust up or down arrow buttons. Adjust the temperature of a Timed Dry Cycle by pressing TEMPERAlURE until the desired temperature is selected. NOTE: You cannot use the Dryness level with Timed Dry Cycles. Follow the progress of your dryer with the drying Status indicator lights. WET DAMP COOL DOWN DRY WRINKLE PREVENT CONTROLS LOCKED !_i; CLEAN LINT SCREEN i_!i= Wet [he Wet light illuminates at the beginning of an Auto Cycle if a wet item is detected. • In an Sensor Dry Cycle, if a wet item is not detected after approximately 5 minutes, the dryer goes directly into Cool Down and the Cool Down and WR[NKI.E PREVENT indicators illuminate, if selected. • In a limed Dry Cycle, wet items are not detected. The dryer will continue to run for the length of time selected, and the Wet light will illuminate. ]he damp light will not illuminate. Damp the [}amp light illuminates in an Sensor Dry Cycle when the laundry is approximately 80% dry. Cool Down [he Cool Down light illuminates during the cool down [)art of the cycle, laundry cools for ease in handling. Dry [he [Dry light illuminates WRINK[E PREVENT. when the drying cycle is finished. This indicator stays on during WRINKLE PREVENT [he WRINKI.E PREVENT light illuminates when this option is selectee]. This indicator stays on with Dry. Clean Lint Screen [he Clean [.int Screen light is a reminder to check to see whether the lint screen needs to be cleaned. The Clean lint Screen light will come on when the machine is turned on. The light will flash until the cycle is started or the door is opened, and then the light will turn off. Indicator lights Other indicator lights show Cycle, Options and Modifier settings selectee|.