Maytag MFT2771WEW User Instructions - Page 14

TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. In the U.S.A., www.maytag.com In Canada, www.maytag.ca The refrigerator will not operate Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to foUow these instructions can result in death, fire, or electrical shock. Power cord unplugged? Plug intoa grounded 3 prong outlet. Is outlet working? Plug in a lamp to see if the outlet is working. Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. Are controls on? Make sure the refrigerator controls are on. See "Using the Control(s)." New installation? Allow 24 hours following installation for the refrigerator to cool completely. NOTE: Adjusting the temperature controls to coldest setting will not cool either compartment more quickly. The motor seems to run too much Your new refrigerator may run longer than your old one due to its high-efficiency compressor and fans. The unit may run even longer if the room is warm, a large food load is added, doors are opened often, or if the doors have been left open. The refrigerator seems noisy Refrigerator noise has been reduced over the years. Due to this reduction, you may hear intermittent noises from your new refrigerator that you did not notice from your old model. Below are listed some normal sounds with explanations. Buzzing - heard when the water valve opens to fill the ice maker • Pulsating - fans/compressor adjusting to optimize performance • Hissing/Rattling - flow of refrigerant, movement of water lines, or from items placed on top of the refrigerator • Sizzling/Gurgling - water dripping on the heater during defrost cycle • Popping - contraction/expansion of inside walls, especially during initial cool-down • Water running - may be heard when ice melts during the defrost cycle and water runs into the drain pan • Creaking/Cracking ice maker mold. - occurs as ice is being ejected from the The doors will not close completely • Door blocked open? Move food packages away from door. • Bin or shelf in the way? Push bin or shelf back into the correct position. The doors are difficult to open Explosion Hazard Use nonflammable cleaner. Failure to do so can result in death, explosion, or fire. • Gaskets dirty or sticky? Clean gaskets and contact surfaces with mild soap and warm water. Rinse and dry with soft cloth. 14