Maytag MGD6630HW Installation Instructions - Page 13
Remove center screw, Connect remaining wires, Connect neutral wire, Wire Power Supply Cord
View all Maytag MGD6630HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
4. Connect remaining wires 2. Connect neutral wire Connect remaining wires under outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now go to "Venting Requirements." 3-Wire Power Supply Cord Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. Connect neutral wire (white or center) (C) of power supply cord under center terminal block screw (B). Tighten screw. 3. Connect remaining wires 3-wire receptacle (NEMA type 10-30R) 3 prong plug Spade terminals with upturned ends Ring terminals 1. Remove center screw Connect remaining wires under outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now go to "Venting Requirements." Remove center terminal block screw (B). 13