Maytag MGD6630HW Installation Instructions - Page 28
Reverse Door Swing: Square-shaped Door
View all Maytag MGD6630HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
REVERSE DOOR SWING: SQUARE-SHAPED DOOR 1. Remove door from dryer 3. Remove inner door from outer door Release tab Release tab Using a T25® screwdriver, remove the four screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Retain or set aside the four screws. 2. Move the door strike Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 13 screws securing the inner door to the outer door. Lift off the inner door and set aside. NOTE: There is a small release tab on each side of the door. If the inner and outer door do not separate easily, slide a credit card, putty knife, or similar flat object between the inner and outer doors at the locations shown to release the tab. 4. Remove hinge and latch from inner door Hinge Using a T25® screwdriver, remove the two screws securing the door strike to the door frame of the dryer. Remove the four screws above and below the door strike and set aside for later use. Rotate the strike 180° and attach to the opposite side of dryer door frame, as shown. Latch Using a T25® screwdriver, remove the three screws securing the latch plate and the five screws holding the hinge assembly in place. 28