Maytag MGR5765QDW Use and Care Guide - Page 11

Moisture collects on oven window or steam comes from oven vent. • This is normal when cooking foods high in moisture. • Excessive moisture was used when cleaning the window. There is a strong odor or light smoke when oven is turned on. • This is normal for a new range and will disappear after a few uses. Initiating a clean cycle will "burn off" the odors more quickly. • Turning on a ventilation fan will help remove the smoke and/or odor. • Excessive food soils on the oven bottom. Use a self-clean cycle. Fault Codes • BAKE or LOCK may flash rapidly in the display to alert you if there is an error or a problem. If BAKE or LOCK appear in the display, press the CANCEL pad. If BAKE or LOCK continue to flash, disconnect power to the appliance. Wait a few minutes, and then reconnect power. If the flashing still continues, disconnect power to the appliance and call an authorized servicer. • If the oven is heavily soiled, excessive flareups may result in a fault code during cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out excess soil, then reset the clean cycle. If the fault code reappears, contact an authorized servicer. Noises may be heard. • The oven makes several low level noises. You may hear the oven relays as they go on and off. This is normal. • As the oven heats and cools, you may hear sounds of metal parts expanding and contracting. This is normal and will not damage your appliance. There are no beeps and no display. • Oven may be in Sabbath Mode. See page 16. SAb flashing and then displayed continuously. • Oven is in Sabbath Mode. To cancel, press and hold the Clock pad for five seconds. Surface Cooking Surface Controls CAUTION • If flame should go out during a cooking operation, turn the burner off. If a strong gas odor is detected, open a window and wait five minutes before relighting the burner. • Be sure all surface controls are set in the OFF position before supplying gas to the range. • NEVER touch cooktop until it has cooled. Expect some parts of the cooktop, especially around the burners, to become warm or hot during cooking. Use potholders to protect hands. Pilotless Ignition Pilotless ignition eliminates the need for a constant standing pilot light. Each surface burner has a spark ignitor. Use care when cleaning around the surface burner. If the surface burner does not light, check if ignitor is broken, soiled or wet. Surface Control Knobs Use to turn on the surface burners. An infinite choice of heat settings is available from LO to HI. At the HI setting a detent or notch may be felt. The knobs can be set on or between any of the settings. Graphics next to the knob identify which burner the knob controls. For example, the graphic at right shows the left front burner location. Setting the controls: The size and type of cookware will affect the heat setting. 1. Place a pan on the burner grate. • The burner flame may lift off or appear separated from the port if a pan is not placed on the grate. 2. Push in and turn the knob counterclockwise to the LITE setting. • A clicking (spark) sound will be heard and the burner will light. (All four ignitors will spark when any surface burner knob is turned to the LITE position.) 3. After the burner lights, turn knob to desired flame size. • The ignitor will continue to spark until the knob is turned past the LITE position. 10