Maytag MGR7775 Installation Instructions - Page 16

To Convert Oven Broil Burner Use a 1/2"combination wrench to turn the orifice hood down snug onto the pin (about 2 to 21/2turns). IMPORTANT: Do not overtighten. The oven broil burner flame cannot be properly adjusted if this conversion is not made. See "Adjust Oven Broil Burner Flame" in the "Electronic Ignition System" section. / / A. Lock screw B. Orifice hood Complete Installation 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Refer to the "Electronic Ignition System" section for proper burner ignition, operation, and burner flame adjustments. IMPORTANT: You may have to adjust the "LO" setting for each cooktop burner. Checking for proper cooktop, bake and broil burner flame is very important. The small inner cone should have a very distinct blue flame 1¼,,(0.64 cm) to 1/2"(1.3 cm) long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip. 3. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to complete this procedure. Tip Over Hazard A child or adult can tip the range and be killed. Connect anti=tip bracket to rear range foot. Reconnect the anti=tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. 1= Turn the manual shutoff valve to the closed position. 2. Unplug range or disconnect power. S...... A '_ ..........C A. Torange B. Manual shutoff valve "dosed" position C. Gas supply fine To Convert Gas Pressure Regulator 1. Remove storage drawer or warming drawer. See "Replace Oven Racks and Storage or Warming Drawer" section. 2. Locate gas pressure regulator at rear of storage or warming drawer compartment. NOTE: On models with a warming drawer, an access cover must be removed from the gas pressure regulator. A A. Gas pressure regulator IMPORTANT: Do not remove the gas pressure regulator. 3. Remove plastic cover from gas pressure regulator cap. 16