Maytag MHW3000BW Use & Care Guide - Page 6
Control Panel And Features, Using The Dispenser Drawer - front load washer
View all Maytag MHW3000BW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
CONTROL PANEL AND FEATURES Cycle Status Lights Delay If a Delay Start is set, the Delay Start indicator will light and the delay time will count down in the display. Door Locked Door Locked will light to indicate that the door is locked and cannot be opened without first pausing or canceling the cycle. Sensing (on some models) When START is touched and held, the washer will first perform a self-test on the door lock mechanism and the sensing light will come on. You will hear a click, the drum will make a partial turn, and the door will unlock briefly before locking again. Once the door has locked the second time, the washer will drain to calibrate the sensors; then it will begin tumbling and adding water. The sensing process will continue throughout the cycle. You may also hear water flowing through the dispenser, adding detergent to the load. After the load size is sensed, the estimated time based on load size will be displayed. The actual cycle time may be lengthened; however, the display will continue to show the estimated time. The sensing light will blink once a second at various times during the cycle, such as when the washer is reducing extra suds. Add a Garment When "Add a Garment" is lit, you may pause the washer, open the door, and add items. Done Once the cycle is complete, this light will come on. Remove the load promptly for best results. The Done indicator is also lit during Fresh Spin™ option. USING THE DISPENSER DRAWER 1. Open the dispenser drawer. 2. Add laundry products as described in steps 4-6 in the "Using Your Washer" section. 3. Slowly close the dispenser drawer. Make sure it is completely closed. NOTE: A small amount of water may remain in the dispensers from the previous wash cycle. This is normal. Adding HE detergent to dispenser Selector HE detergent compartment Pour a measured amount of HE detergent into detergent compartment. For powdered detergent, lift the selector to the high position. For liquid detergent, push down the selector to the low position. Use only High Efficiency Do not overfill; adding too much detergent (HE) detergent. may cause detergent to be dispensed into the washer too early. Selector in high position Selector in low position Powdered detergent: Lift the selector to the high position. Liquid detergent: Push down the selector to the low position. IMPORTANT: n Do not add single-dose laundry packet to dispenser drawer. n Use powdered detergent when using the Delay Start option. Liquid detergent may seep out before the wash begins. 6