Maytag MHW4200BW Use & Care Guide - Page 18

TROUBLESHOOTING First try the solutions suggested here or visit our website at www.maytag.com/product_help - In Canada www.maytag.ca for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Washer not performing as expected (cont.) Washer won't run or fill, Check for proper water supply. washer stops working Both hoses must be attached and have water flowing to inlet valve. Both hot and cold water faucets must be turned on. Check that inlet valve screens have not become clogged. Check proper electrical supply. Check for any kinks in inlet hoses, which can restrict water flow. Plug power cord into a grounded 3-prong outlet. Do not use an extension cord. Ensure there is power to outlet. Normal washer operation. Check electrical source or call an electrician to check if voltage is low. Reset a tripped circuit breaker. Replace any blown fuses. NOTE: If problems continue, contact an electrician. Door must be completely closed and latched for washer to run. Washer will pause during certain phases of cycle. Do not interrupt cycle. The washer pauses for about 2 minutes during certain cycles. Allow the cycle to continue. Some cycles feature periods of tumbling and soak. Washer may be stopped to reduce suds. Cold Wash uses less water in the beginning of the cycle to provide a high concentration of detergent for optimal cleaning action. Following this concentrated tumbling, more water is used to complete the wash. The washer door is not firmly shut. The door must be closed during operation. Washer not loaded as recommended. Remove several items, rearrange load evenly in washer drum. Close door and touch and hold START. Do not add more than 1 or 2 additional items after cycle has started to avoid tightly packing or unbalancing. Do not add more water to the washer. 18