Maytag MHW4200BW Use & Care Guide - Page 20

TROUBLESHOOTING First try the solutions suggested here or visit our website at www.maytag.com/product_help - In Canada www.maytag.ca for assistance and to possibly avoid a service call. If you experience Possible Causes Washer not performing as expected (cont.) Desired setting or option does not light For best performance, not all settings are available with each cycle, and some options cannot be used together. Solution See the "Cycle Guide" for the available settings and options for each cycle. Load not rinsed Check for proper water supply. Make sure hot and cold inlet hoses are not reversed. Both hoses must be attached and have water flowing to the inlet valve. Both hot and cold water faucets must be on. Inlet valve screens on washer may be clogged. Remove any kinks in the inlet hose. Load is wrinkled, twisted, or tangled Not using HE detergent or using too much HE detergent. The suds from regular detergent can cause the washer to operate incorrectly. Use only HE detergent. Always measure detergent and follow manufacturer's directions based on load size and soil level. Washer not loaded as recommended. The load may be out of balance. Avoid tightly packing the washer. The washer will not rinse well if tightly packed. Load with dry items only. See the "Cycle Guide" for load size recommendations for each cycle. Use cycle designed for the fabrics being washed. Add only 1 or 2 garments after washer has started. When load unbalance occurs, a washing process will start to redistribute the load. This may lengthen the cycle time. Avoid washing single items. Balance a single item such as a rug or jeans jacket with a few extra items. Washer not loaded as recommended. Add load loosely. Items need to move freely reduce wrinkling and tangling. See the "Cycle Guide" for load size recommendations for each cycle. Reduce tangling by mixing types of load items. Use the recommended cycle for the type of garments being washed. Wash action and/or spin speed too high for load. Select a lower spin speed. Note that items will be wetter than when using a higher speed spin. The washer is not unloaded promptly. Unload the washer as soon as it stops or use Fresh Spin™ option if you will not be able to unload the washer at the end of the cycle. Not choosing the right cycle for the load Use the Delicates cycle or another cycle with a low spin speed being washed. to reduce wrinkling. The wash water was not warm enough If safe for load, use warm or hot wash water. to relax wrinkles. Not cleaning or removing stains Washer not loaded as recommended. Not using HE detergent or using too much HE detergent. Hard water or high level of iron (rust) in water. Fabric softener dispensing ball used. Powdered detergent used for low-speed cycle. Add load loosely. Items need to move freely for best cleaning. See the "Cycle Guide" for load size recommendations for each cycle. Add only 1 or 2 garments after washer has started. Use only HE detergent. Always measure detergent and follow manufacturer's directions based on load size and soil level. You may need to install a water softener and/or iron filter. Dispensing balls will not operate correctly with this washer. Add liquid fabric softener to the fabric softener compartment. Consider using liquid detergent. 20