Maytag MSD2272VEW User Instructions - Page 15

Base Grille Water Filtration System Model P2WG2L/P2RFWG2 Capacity 200 Gallons (757 Liters) Model P2WG2/P2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Benzene, Toxaphene, and O-dichlorobenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53. Substance Reduction Aesthetic Effects Chlorine Taste/Odor Particulate Class I* Contaminant Reduction Lead: @ pH 6.5 Lead: @ pH 8.5 Mercury: @ pH 6.5 Mercury: @ pH 8.5 Benzene O-Dichlorobenzene Toxaphene NSF Reduction Requirements 50% reduction 85% reduction NSF Reduction Requirements 0.010 mg/L 0.010 mg/L 0.002 mg/L 0.002 mg/L 0.005 mg/L 0.6 mg/L 0.003 mg/L Average Influent 1.909 mg/L 9700000 #/mL Average Influent 143.33 ug/L 140 ug/L 0.0058 mg/L 0.00646 mg/L 0.015 mg/L 1.83333 mg/L 0.016 mg/L Influent Challenge Concentration 2.0 mg/L + 10% At east 1O,OOOpart c es/mL Influent Challenge Concentration 0.15 mg/L + 10% 0.15 mg/L _+10% 0.006 mg/L + 10% 0.006 mg/L_+ 10% 0.015 mg/L _+10% 1.8 mg/L _+10% 0.015 mg/L _+10% Maximum Effluent 0.05 mg/L ** 2600 #/mL Maximum Effluent 1.0 ug/L 1.0 ug/L 0.3 ug/L 1.4 ug/L 0.5 ug/L 4.8 ug/L 1 ug/L Average Effluent 97.4 >97,6 Minimum % Reduction >99.3 >99.3 >96.5 76.3 >96.5 99.7 >93.2 Average % Reduction >97.4 >99,4 Average % Reduction >99.3 99.3 96.5 88.1 >96.5 99.9 >93.2 Test Parameters: pH = 7.5 + 0.5 unless otherwise noted. Flow = 0.85 gpm (3.2 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters). • It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. • Use replacement filter P2RFWG2, part #4396841. 2008 suggested retail price of $39.99 U.S.A./S54.95 Canada. Prices are subject to change without notice. Model P2WG2L/P2WG2: Style 1 - When the filter indicator reads 10%, order a new filter. When the indicator reads 0%, it is recommended that you replace the filter. Style 2 - When the filter indicator changes from green to yellow, order a new filter. When the indicator changes from yellow to red, it is recommended that you replace the filter. Style 3 - When the water filter status display changes from "GOOD" to "ORDER," order a new filter. When the filter indicator reads "REPLACE," it is recommended that you replace the filter. Style 4 - Press FILTER to check the status of your water filter. If the filter indicator light is yellow, order a new filter. If the filter indicator light is red, it is recommended that you replace the filter. Change the water filter cartridge every 6 months. If the water flow to the water dispenser or ice maker decreases noticeably before 6 months have passed, replace the water filter cartridge more often. • These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. • The product is for cold water use only. • Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. • Refer to the "Warranty" section for the Manufacturer's name, address and telephone number. • Refer to the "Warranty" section for the Manufacturer's limited warranty. Application Guidelines/Water Supply Parameters Water Supply Water Pressure Water Temperature Service Flow Rate City or Well 30 - 120 psi (207 - 827 kPa) 33 ° - 100°F (0.6 ° - 37.8°C) 0.85 gpm (3.2 Lpm) @ 60 psi *Class I particle size: >0.5 um to