Maytag MSD2272VEW User Instructions - Page 9

NOTE: Not all bulbs will fit your refrigerator. Be sure to replace the bulb with one of the same size, shape and wattage. On some models, the dispenser light requires a heavy duty 1O-watt bulb. All other lights require a 40-watt bulb. Replacement bulbs are available from your dealer. 1. Unplug refrigerator or disconnect power. 2. Remove light shield when applicable. NOTE: To clean the light shield, wash it with warm water and liquid detergent. Rinse and dry the shield well. 3. Remove light bulb and replace with one of the same size, shape and wattage. 4. Replace light shield when applicable. 5. Plug in refrigerator or reconnect power. TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. In the U.S.A., www.maytag.com In Canada, www.maytag.ca The refrigerator will not operate Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Power cord unplugged? Plug into a grounded 3 prong outlet. Is outlet working? Plug in a lamp to see if the outlet is working. Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. Are controls on? Make sure the refrigerator controls are on. See "Using the Controls." New installation? Allow 24 hours following installation for the refrigerator to cool completely. NOTE: Adjusting the temperature controls to coldest setting will not cool either compartment more quickly. The motor seems to run too much Your new refrigerator may run longer than your old one due to its high-efficiency compressor and fans. The unit may run even longer if the room is warm, a large food load is added, doors are opened often, or if the doors have been left open. The refrigerator is noisy Refrigerator noise has been reduced over the years. Due to this reduction, you may hear intermittent noises from your new refrigerator that you did not notice from your old model. Below are listed some normal sounds with an explanation. Buzzing - heard when the water valve opens to fill the ice maker • Pulsating - fans/compressor adjusting to optimize performance • Rattling - flow of refrigerant, water line, or from items placed on top of the refrigerator • Sizzling/Gurgling - water dripping on the heater during defrost cycle • Popping - contraction/expansion of inside walls, especially during initial cool-down • Water running - may be heard when water melts during the defrost cycle and runs into the drain pan • Creaking/Cracking ice maker mold. - occurs as ice is being ejected from the The doors will not close completely • Door blocked open? Move food packages away from door. • Bin or shelf in the way? Push bin or shelf back in the correct position.