Maytag MSD2650HEB Use and Care Guide - Page 14

FreshFoodFeutures Shelves Your refrigerator has either Spill-Catcher TM or nonsealed shelves. Spill-Catcher TM shelves have a spill retainer edge which allows for easier clean up and some are equipped with the Easy-Glide slide out feature. To slide out (select models), grasp the front of the shelf and pull forward. Push in the shelf to return to the original position. To Remove a Shelf: • Slightly tilt up the front and lift up the rear of the shelf, then pull the shelf straight out. To Lock the Shelf Into Another Position: • Tilt up the front edge of the shelf. • Insert the hooks into the desired frame openings and let the shelf settle into place. • Be sure the shelf is securely locked at the rear. The Crisper Top serves as the lower fresh food shelf. To Remove the Crisper Top: • Remove drawers as indicated (see page 14). • Place hand under the frame to push up the glass. Lift glass out. To Install: • Repeat above instructions in reverse order. Elevator TM Shelf (select models) The Elevator TM Shelf is equipped with a spill-retaining edge and the Easy-Glide TM slide-out feature. It can be adjusted up or down without unloading. 13 To Slide Out Elevator TM Shelf: • Grasp the front of the shelf and pull forward. • Push the shelf in to return to original position. To Adjust the Elevator TM Shelf: • Pull out the knob on the crank handle. • Rotate the crank clockwise to raise the shelf, and counterclockwise to lower the height of the shelf. To Remove Elevator TM Shelf: • Completely unload the shelf and pull the shelf forward. Pull until the shelf stops. Press up on the tabs located underneath its outside edges and continue pulling forward until the shelf is clear of the frame. To Replace Elevator TM Shelf: • Align the shelf to the frame and push it all the way back. It is not necessary to press up on the tabs for reinstallation. In ordinary use, the Elevator TM Shelf frame assembly does NOT require removal. Though unlikely, and not recommended, the correct removal procedure is as follows: To Remove Frame Assembly: • Unload the shelf completely. • Slide the shelf forward about 2" and manually move the two rear latches toward the shelf center. • While supporting the entire shelf and frame from underneath, lift slightly and rotate the assembly approximately 30 ° to allow the rear mechanism to clear the vertical rear side rails. • The entire assembly can then be moved forward and clear of the refrigerator compartment. To Reinstall Frame Assembly: • Reverse the removal procedure. Be sure the shelf is in a level position. When the sliding shelf is pushed to the rear, it will reposition the rear latches to their correct operating position. (style may vary) Frame AssemNy SmideOut Shdf